Reduce Cost, Improve Floor Care Equipment Productivity with Training - Sponsored Learning
Correlating Products and Procedures For Food Preparation Areas
Products and procedures for sanitizing and disinfecting, especially around food preparation areas, should meet the requirements for the task at hand.
“Disinfectants should be EPA registered and carry the proper kill claims,” says Teresa Farmer, sustainability consultant for Knoxville, Tenn.-based Kelsan Inc. “And products used in foodservice should be purchased based on performance, not price. This should not be an area where someone tries to save money.”
While there is myriad disinfecting products on the market, distributors say quaternary-based products are the most effective and widely used.
“They give a full kill range on organisms, and they are less corrosive,” says Steve Rathbun, janitorial sales manager for Cedar Falls, Iowa-based Martin Brothers Distributing Co., Inc. “While chlorine is most economical, there are certain surfaces, like fabrics, that you can’t use bleach on. And bleach can be dangerous if you mix it with raw chemicals. So the quaternary-based products are safe overall and still economical.”
Most stainless steel cleaners, a staple in the foodservice cleaning arsenal, are petroleum-based and will need to be rinsed thoroughly with potable water.
“There are some soy mineral oil-based products that are claiming they don’t need to be rinsed, and that makes the job a little easier,” says Rathbun.
Surfaces that hold food, such as preparation boards and tables where people sit to eat, should be wiped with clean cloths.
“A table shouldn’t be cleaned with a damp rag that is used over and over,” says Farmer. “Best practices dictate that a sanitizer be used, along with either a microfiber or disposable cloth. Carrying germs from one area to another on a dirty rag is a major cause of cross-contamination.”
If possible, gloves should be worn by the people preparing food and by the person clearing and cleaning the tables. This provides additional protection to foodservice workers and to eating patrons.
Kitchens in most restaurants, hospitals and business cafeterias are sophisticated, high-tech environments. Still, they need to be cleaned with an attention to mopping and scrubbing detail. To get to that level of clean, many companies are turning to the use of specialty machines to get the job done.
“There are more tile floors in kitchens, which are difficult to keep clean,” says Rathbun. “They are generally mopped and mopping doesn’t clean the floor very well. So we’re starting to see more people go towards specialty equipment, which will get grease off the floor better.”
To prevent cross-contamination, and keep things more organized, the jan/san industry now offers a multitude of color-coded products and chemicals. For instance, if the produce section of a grocery store is deemed green, all the cutting boards, brushes, mops and brooms should be color-coded green, as well.
“Then we can take the next step and color-code the chemicals [with labels],” says Tom Dougherty, healthcare and janitorial sales manager for Philadelphia-based Penn Jersey Paper. “Then we’re not using bleach where we shouldn’t be using bleach.”
Emphasize Continuous Training
To be assured of proper foodservice sanitation and infection control for customers, thorough, understandable and regular training must take center stage.
“I was training in the kitchen of a large winery. They are incredibly concerned about sanitation,” says Leland Fishman, president of Petaluma, Calif.-based Fishman Supply Co. “We went over microfiber use with the housekeeping staff, and then we did a 20 minute training session on how to ionize the water used in cleaning bar tops. This winery has been completely remodeled, and all of their sanitation procedures are going to change.”
One of the biggest difficulties in providing consistent food sanitation training is getting all of the restaurant or cafeteria staff together at one time.
“Getting all the staff together is best, but if you’re trying to train employees in a 24-hour restaurant, that’s pretty impossible,” says Rathbun. “In that case, set up an appointment and do one-on-one training with employees.”
Many distributors also are relying on teaching aids, such as training cards. These cards show cleaning processes and procedures in a step-by-step picture format.
“That kind of simple training works really well because you tend to have a lot of language barriers, depending on the cleaning staff,” says Dougherty. “Simplistic training videos, cards and other documentation can be very effective training devices. Keep it as simple and efficient as possible. And make sure you are doing reinforcement training on a weekly, monthly and quarterly basis.”
Farmer agrees, adding internal routine inspections to the mix to ensure that employees are properly cleaning around food preparation areas.
Partnership is also the key. By showing customers how to effectively use sanitation and disinfecting products around food and food service areas, along with demonstrating the proper training of staff, it can go a long way in preventing an unwanted foodborne outbreak.
“We don’t so much need to give them ways to cut costs as to show them more efficient and effective ways to sanitize and disinfect,” says Dougherty. “The onus is on us, the distributors and manufacturers, to show them better ways.”
Fishman couldn’t agree more.
“Our industry has to get better at consultative selling; that is being a consultant on top of being a salesperson,” he says. “We’ve got to do this better.”
This is particularly true in foodservice sanitation and infection control, where the advice a distributor gives, and the training a distributor conducts, just might save a reputation — and a life.
Cynthia Kincaid is a freelancer based in Columbus, Ohio.
Disclaimer: Please note that Facebook comments are posted through Facebook and cannot be approved, edited or declined by CleanLink.com. The opinions expressed in Facebook comments do not necessarily reflect those of CleanLink.com or its staff. To find out more about Facebook commenting please read the Conversation Guidelines.